Rohde & Schwarz R&S SMW200A - Page 918

Remote Control Commands
R&S
®
SMW200A
918User Manual 1175.6632.02 ─ 30
The available values depend on the selected MIMO configuration.
For example:
●
In MIMO configurations with fewer than 8 channels, the max. baseband bandwidth
is 400 MHz.
●
In MIMO configurations with fewer than 4 channels, the max. baseband bandwidth
is 800 MHz.
Parameters:
<Bandwidth> BB040 | BB050 | BB080 | BB100 | BB160 | BB200 | BB800 |
BB400 | BB500 | BB1G | BB2G | BB120 | BBOUTDEF | BB240
BB040|BB050 ...
Bandwidth in MHz, e.g. 40 MHz.
BB1G|BB2G
1 GHz, 2 GHz bandwidth.
Available in SISO configurations.
BBOUTDEF
Bandwidth determined by the signal at the HS DIG I/Q.
Example: See Example "Enbaling signal with 400 MHz fading bandwidth"
on page 911.
Options: R&S SMW-K822
BB800 requires R&S SMW-K823
Manual operation: See "BB Bandwidth" on page 130
:SCONfiguration:CABW?
Queries the resulting channel aggregation bandwidth, i.e. the signal bandwidth at the
outputs of the stream mapper.
The value is calculated automatically and depends on the selected configuration, the
installed options and the selected baseband bandwidth (:SCONfiguration:BBBW).
Return values:
<Bandwidth> BB800 | BB200
*RST: depends on options
Example: See Example "Enbaling signal with 400 MHz fading bandwidth"
on page 911.
Usage: Query only
Options: R&S SMW-K822/K823
Manual operation: See "CA Bandwidth" on page 130
:SCONfiguration:DIQ:BBMM1:CHANnels <DigIqHsBBMM1cha>
:SCONfiguration:DIQ:BBMM2:CHANnels <DigIqHsBBMM2Cha>
In :SCONfiguration:OUTPut:MODEHSDigital|HSAL, sets the number of digital
channels on the HS DIG I/Q interface.
SCONfiguration Subsystem