Remote Control Commands
R&S
®
SMW200A
915User Manual 1175.6632.02 ─ 30
ADVanced|STANdard
Switches between the Standard mode and Advanced mode.
REGenerator
Enables the R&S SMW to work as a radar echo generator.
The fading simulator is disabled.
See user manual R&S®SMW-K78 Radar Echo Generation.
GNSS
Enables the R&S SMW to work as in advanced GNSS mode.
The fading simulator is disabled.
See user manual R&S®SMW Satellite Navigation.
ESEQuencer
Enables the R&S SMW to work in an advanced extended
sequencer mode.
The fading simulator, the AWGN, the BB input and all baseband
digital standards are disabled.
See user manual R&S®SMW-K501/-K502/-K503/-K504/-K315
Extended and Real-Time Sequencing, Real-Time Control Inter-
face, Extended Pulse Rate, Permanent Emitters.
*RST:
STANdard
Example: See Example "Distributing the I/Q streams to the output connec-
tors" on page 904.
Options: REGenerator requires option R&S SMW-K78
GNSS requires option R&S SMW-K120
ESEQuencer requires options R&S SMW-B15/-K315
Manual operation: See "Mode" on page 126
:SCONfiguration:OUTPut:MODE <Mode>
Defines what kind of signal is generated and which output interfaces are enabled.
Parameters:
<Mode> DIGMux | DIGital | ALL | ANALog | HSDigital | HSALl
ALL
Output at the analog (RF and I/Q) and the digital DIG I/Q interfa-
ces.
DIGital | DIGMux
Signal is output as single stream or multiplexed digital signal at
the DIG I/Q interfaces.
ANALog
Output at the analog (RF and I/Q) interfaces.
HSDigital
Output at the interfaces HS DIG I/Q interfaces.
HSALl
Output at the analog (RF and I/Q) and the digital HS DIG I/Q
interfaces.
*RST:
ALL
SCONfiguration Subsystem
To Next Page
Loading...