Rohde & Schwarz R&S SMW200A - Output Subsystem

Remote Control Commands
R&S
®
SMW200A
885User Manual 1175.6632.02 ─ 30
Parameters:
<Layout> CHINese | DANish | DUTCh | DUTBe | ENGLish | ENGUK |
FINNish | FRENch | FREBe | FRECa | GERMan | ITALian |
JAPanese | KORean | NORWegian | PORTuguese | RUSSian |
SPANish | SWEDish | ENGUS
*RST: n.a. (factory preset: ENGLish)
Example:
:KBOard:LAYout US
// activates American keyboard
Manual operation: See "USB Keyboard > Layout" on page 711
14.16 OUTPut Subsystem
In the OUTPut subsystem, you can configure the output signals.
The LF output signal is defined with the commands of the Chapter 14.19.11,
"SOURce:LFOutput Subsystem", on page 1152 system.
Common suffixes
The following common suffixes are used in remote commands:
Suffix Value range Description
OUTPut<hw>
[1] | 2 Signal path
:OUTPut:ALL[:STATe]..................................................................................................... 885
:OUTPut<hw>[:STATe]....................................................................................................886
:OUTPut<hw>[:STATe]:PON............................................................................................886
:OUTPut<hw>:AMODe................................................................................................... 886
:OUTPut<hw>:BLANk:LIST:STATe................................................................................... 887
:OUTPut<hw>:IMPedance?.............................................................................................887
:OUTPut<hw>:AFIXed:RANGe:LOWer?...........................................................................887
:OUTPut<hw>:AFIXed:RANGe:UPPer?............................................................................887
:OUTPut<hw>:PROTection:CLEar................................................................................... 888
:OUTPut<hw>:PROTection:STATe................................................................................... 888
:OUTPut<hw>:PROTection:TRIPped?..............................................................................888
:OUTPut:ALL[:STATe] <State>
Activates all RF output signals of the instrument.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 0)
Example:
:OUTPut:ALL:STATe 0
Switches off all RF output signals.
Manual operation: See "RF State/RF ON" on page 460
OUTPut Subsystem