Rohde & Schwarz R&S SMW200A - Segment Table

Configuring the Internal Baseband Source
R&S
®
SMW200A
361User Manual 1175.6632.02 ─ 30
Remote command:
To define the configuration file (*.inf_mswv) used by the calculation of the output file:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CREate
Or [:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad
To define the filename of the output waveform file (*.wv):
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe
5.10.3.2 Segment Table
Access:
1. Select "Baseband > ARB > General > Multi Segment".
2. In the "ARB: Multi Segment > General" dialog, select an existing list.
3. Select "ARB: Multi Segment > Segment Table".
4. Select "Append" to add existing waveform segments.
5. Select "Append Blank" to add a bank segment and configure the "Blank Segment
Settings" as required.
This section explains the settings, necessary to create and adjust the contents of
the multi-segment file.
Settings:
Multi Segment Table....................................................................................................362
Append/Delete/Shift Seg. Up/Down............................................................................362
Blank Segment............................................................................................................362
Generating Multi-Segment Waveform Files