Rohde & Schwarz R&S SMW200A - RF State

Signal Routing and System Configuration
R&S
®
SMW200A
143User Manual 1175.6632.02 ─ 30
:SCONfiguration:EXTernal:IQOutput<ch>:RF:FREQuency on page 927
:SCONfiguration:EXTernal:IQOutput<ch>:RF:FREQuency:OFFSet
on page 927
:SCONfiguration:EXTernal:IQOutput<ch>:RF:POWer on page 928
:SCONfiguration:EXTernal:IQOutput<ch>:RF:POWer:OFFSet on page 928
:SCONfiguration:EXTernal:RF<ch>:RF:FREQuency on page 927
:SCONfiguration:EXTernal:RF<ch>:RF:FREQuency:OFFSet on page 927
:SCONfiguration:EXTernal:RF<ch>:RF:POWer on page 928
:SCONfiguration:EXTernal:RF<ch>:RF:POWer:OFFSet on page 928
RF State
With enabled "RF Coupled" parameter, displays the RF output state of the connected
external instrument. The parameter is coupled to the state of the RF output of the
R&S SMW.
In uncoupled mode, enables/disables the RF output in the external instrument.
Remote command:
:SCONfiguration:EXTernal:FADer<ch>:RF:STATe on page 929
:SCONfiguration:EXTernal:BBMM<ch>:IQConnection:STATe? on page 926
:SCONfiguration:EXTernal:IQOutput<ch>:RF:STATe on page 929
:SCONfiguration:EXTernal:RF<ch>:RF:STATe on page 929
4.4.3.2 External Instrument Configuration Settings
Access:
1. Select "Taskbar > System Config > System Configuration > External RF and I/Q".
2. Navigate to the required connector.
Select "External Instruments > Config ...".
The "<Dig. Conn. Name>: External Instrument Configuration" dialog opens and dis-
plays the "External Instrument Configuration > Remote Config" settings.
System Configuration Settings