Getting Started
R&S
®
SMW200A
69User Manual 1175.6632.02 ─ 30
To learn more and to explore the whole range of routing capability, refer to Chapter 4,
"Signal Routing and System Configuration", on page 106.
3.3.6 Verifying the Generated Signal
It is often useful to check the spectra of the configured signals, before you enable the
RF output of the instrument.
The R&S SMW provides a build-in function to represent the generated signal on a
graphical signal display. We demonstrate this feature by showing the characteristics at
one particular point of the signal processing chain. You can, however, display the sig-
nal characteristics at other different stages.
This example shows you how to use this graphical display to verify the generated sig-
nal. Use the signal generated in Chapter 3.3.5, "Routing a Baseband Signal to the Out-
puts", on page 64.
To access the graphical signal display functionality
► Perform one of the following:
a) Select "Taskbar > System Configuration > Graphics"
b) On the "Taskbar", tap the wave icon.
The "Graphics Configuration" dialog opens.
To visualize the sum signal
1. In the "Graphics Configuration" dialog, select "Mode > Power Spectrum".
2. Select "Source > A Stream".
3. Select "Add" to enable signal display.
Trying Out the Instrument
To Next Page
Loading...