Getting Started
R&S
®
SMW200A
68User Manual 1175.6632.02 ─ 30
Stream A is routed to all the available output connectors: the analog RF A and I/Q
("I/Q OUT 1") connectors, and the digital I/Q output connectors DIG I/Q
("BBMM1").
2. To reconfigure the mapping, tap a matrix entry, for example disable the output of
stream A on the BBMM 1 interface.
With the "I/Q Stream Mapper", you route the streams; the outputs are, however, not
necessarily activated.
Tip: How to access the settings of the input and output interfaces.
In the block diagram, the blocks related to the input and output interfaces can be
folded for a better overview.
If the block diagram does not show the "I/Q Analog" block, tap the corresponding
connector icon, i.e. "I/Q Out 1/2", to unfold the settings.
The generated composed signal (stream A) is output at the analog "RF A" connec-
tor and routed to the "I/Q Out 1" connector. The block diagram confirms this routing
and displays the letter "A" next to the symbols of the output connectors.
Consider however that the I/Q connectors are disabled.
Trying Out the Instrument
To Next Page
Loading...