Rohde & Schwarz R&S SMW200A - Activating Analog Modulations

Configuring the RF Signal
R&S
®
SMW200A
539User Manual 1175.6632.02 ─ 30
Single
1 = Pulse delay 2 = Pulse width 2 = Pulse Period
Double
1 = Pulse width 2 = Double pulse delay
3 = Double pulse width 4 = Pulse period
8.8.3 Activating Analog Modulations
1. Option: R&S SMW-B9
Select "System Config > Fading/Baseband Config > Mode = Standard".
2. Option: R&S SMW-B10
Use one of the following:
● Select "RF > Amplitude Modulation/Frequency Modualtion/Phase Modualtion >
State > ON".
● Select "Mod Off > Modulation On".
● Press the [MOD ON/OFF] key.
[MOD ON/OFF]
Activate one or more analog modulations and press the [MOD ON/OFF] key to toggle
the state of them all.
Pressing the key again restores the status that was active before the last switch-off.
Remote command:
[:SOURce<hw>]:MODulation[:ALL][:STATe] on page 964
Analog Modulations