Monitoring Signal Characteristics
R&S
®
SMW200A
608User Manual 1175.6632.02 ─ 30
Sample Rate Mode
Sets how the time resolution of the signal is determined. Maximum resolution corre-
sponds to a display covering the entire signal bandwidth. The higher the resolution, the
shorter the length of the displayed signal segment.
"Auto"
The resolution is set to an optimum value in terms of signal and dis-
play type.
"Full Bandwidth"
The resolution is set so that the display covers the entire signal band-
width.
"User"
Activates the "Sample Rate" input field, where you can manually set
the resolution.
Remote command:
[:SOURce<hw>]:BB:GRAPhics:SRATe:MODE on page 1104
Sample Rate
●
If "Sample Rate Mode = Auto/Full Bandwidth"
Displays the percentage of the entire signal bandwidth which is used for the graphi-
cal signal display.
●
If "Sample Rate Mode = User"
Input for the percentage of signal bandwidth which is used for the graphical signal
display.
Remote command:
[:SOURce<hw>]:BB:GRAPhics:SRATe:USER on page 1104
Add
Adds a graphical signal display (as set in the "Graphics Configuration" dialog) to the
taskbar/graphical diagrams table.
Remote command:
[:SOURce]:BB:GRAPhics:ADD on page 1105
Apply Changes
Enables the current settings for the selected graphical signal display.
Remove
Removes the selected graphical signal display from the taskbar/graphical diagrams
table.
Remote command:
[:SOURce]:BB:GRAPhics:CLOSe on page 1104.
Note, that this command closes all graphical signal displays.
9.1.4 Graphical Signal Display Settings
Access:
1. Select "Taskbar > System Config > Graphics > Add".
Displaying Baseband Signal Characteristics in Real-Time
To Next Page
Loading...