Rohde & Schwarz R&S SMW200A - Adjustment Settings

Configuring the RF Signal
R&S
®
SMW200A
478User Manual 1175.6632.02 ─ 30
"Input Signal (loop through)"
Option: R&S SMW-K703/-K704
Passes the external reference frequency to the output directly.
"Same As Reference Input"
(earlier RF hardware versions)
Passes the assigned reference frequency to the output directly.
"10 MHz Derived From Ref. Output"
(earlier RF hardware versions)
Derives a signal with 10 MHz frequency from the reference input and
forwards this signal to the output.
Remote command:
[:SOURce]:ROSCillator:OUTPut:FREQuency:MODE on page 1202
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
A blinking LED on the front/rear panel indicates the selected connector, too (see Chap-
ter 12.2.2.4, "Status Indicators", on page 718).
8.5.4 Adjustment Settings
Access:
1. Select "RF" > "RF Frequency" > "Reference Frequency".
2. Select "Adjustment".
Settings:
Adjustment Active....................................................................................................... 478
Adjustment Value........................................................................................................ 479
Adjustment Active
Selects the adjustment mode.
"Off"
Uses the calibrated internal reference frequency.
"On"
Allows you to apply a deviation to the internal reference frequency,
according to your requirements.
Enter the value in the Adjustment Value field.
Remote command:
[:SOURce]:ROSCillator[:INTernal]:ADJust[:STATe] on page 1202
Reference Oscillator