Rohde & Schwarz R&S SMW200A - Overview

Signal Routing and System Configuration
R&S
®
SMW200A
152User Manual 1175.6632.02 ─ 30
Access:
1. Select "Taskbar > System Config > System Configuration > External RF and I/Q".
2. Select "I/Q OUT x > External Instruments > Config ...".
3. In the "I/Q OUT x: External Instrument Configuration" dialog, select "Connections".
4. Select "Check Connection".
The dialog is a graphical representation of the required connections and their sta-
tus. The connection status indication is color coded.
The dialog shows information on the following:
● Connection check status
● Signal connections status
● Remote control connections status
Remote command:
:SCONfiguration:EXTernal:IQOutput<ch>:CONNections:CHECk?
on page 934
4.4.4 Overview
Access:
► To display an interactive overview diagram of the current configuration, select "Sys-
tem Configuration > Overview".
The overview tab shows information on the following:
● Current stream mapping to the output interfaces, see Chapter 4.4.2, "I/Q
Stream Mapper Settings", on page 132.
● Connected controller (external PC).
System Configuration Settings