Signal Routing and System Configuration
R&S
®
SMW200A
153User Manual 1175.6632.02 ─ 30
● Connections for remote control of connected external I/Q and RF devices, see
Chapter 4.4.3, "External RF and I/Q Settings", on page 135
● Input and output signals, like:
– LO coupling or used external reference frequency.
– Connected external baseband source to the digital input interface.
1
1
2a
2b
2a
2b
3
4a
4b
5a
5b
1 = I/Q streams mapped to the interfaces
2a = State indication for the RF and digital/analog IQ outputs: active
2b = State indication for the RF and digital/analog IQ outputs: inactive
3 = External instrument configured in the "External RF and I/Q" dialog
4a = Gray background color: deactivated RF outputs of the external instrument
4b = Blue background color: activated RF outputs of the external instrument
5a = Remote connection state indicator: existing physical connection with disabled status
5b = Remote connection state indicator: external instrument connected to and operated form the
R&S SMW
Compare the overview representation with the example configuration in External RF
and I/Q Settings.
Hotspots for fast access to the required settings
Several of the displayed elements are hotspots. Select one of the elements listed in
Table 4-7 to access the related dialog.
Table 4-7: Hotspots in the Overview dialog
GUI element Dialog Refer to
"System Controller" "Remote Access Set-
tings"
See Chapter 13.4.6, "Remote Connections Set-
tings", on page 792
"COD 1/2"
or the associated stream
"Baseband Input Set-
tings"
See Chapter 4.6, "Digital Baseband Input Settings",
on page 158
"IQ OUT1/2"
or the associated stream
"I/Q Analog Outputs" See Chapter 4.8, "I/Q Analog Output Settings",
on page 182
System Configuration Settings
To Next Page
Loading...