Rohde & Schwarz R&S SMW200A - Reference Frequency Settings

Configuring the RF Signal
R&S
®
SMW200A
474User Manual 1175.6632.02 ─ 30
For more information, see data sheet.
8.5.2 Reference Frequency Settings
Access:
1. Select "RF" > "RF Frequency" > "Reference Frequency".
In the "Reference Frequency" tab, you can select the reference frequency signal
source and the frequency and synchronization bandwidth mode of an external ref-
erence signal.
2. Observe the information in the status bar of the block diagram.
The status bar indicates the current oscillator configuration.
The remote commands required to define these settings are described in Chap-
ter 14.19.17, "SOURce:ROSCillator Subsystem", on page 1198.
Dependencies on RF hardware versions
The supported external reference frequencies depend on the versions of the RF hard-
ware components, the R&S SMW is equipped with.
See:
●
"Checking the installed hardware options" on page 1266
●
"Checking the RF hardware assembly" on page 1266
●
Appendix: RF Hardware Versions, on page 1289
Settings:
Source.........................................................................................................................475
Show Connector..........................................................................................................475
Deactivate RF Output (if external reference is missing)..............................................475
Reference Oscillator