Troubleshooting and Error Messages
R&S
®
SMW200A
1266User Manual 1175.6632.02 ─ 30
15.7.3 How to Query Instrument Configuration
To get information on the components and installed options of the R&S SMW, proceed
as described in the following examples.
Checking the installed hardware options
To find out the installed options:
1. Select "System Config > Setup > Instrument Assembly > Versions/Options".
2. Select "Hardware Options".
The dialog lists all hardware options that are installed on the R&S SMW.
Proceed the same way to get information for instance on the firmware, or the installed
software options in the corresponding tab.
Checking the RF hardware assembly
To find out the installed RF hardware:
1. Select "System Config > Setup > Instrument Assembly > Hardware Config".
Requesting Instrument Configuration and Specifications
To Next Page
Loading...