Configuring the RF Signal
R&S
®
SMW200A
524User Manual 1175.6632.02 ─ 30
8.7.7 List Editor
The "User Correction" and "List Mode" dialogs provide a build-in list editor for defining
the corresponding value pairs.
The table and navigation functions of the UCOR and list mode editors have the same
structure and are therefore summarized below. The access is specified for both modes,
the fields and functions are explained using the example of the list mode.
Access to "Edit List Mode Data":
► "RF" > "Sweep/List" > "List Mode" > "List Mode Data" > "Edit List Mode Data"
The editor for list mode provides a table with RF frequency and power values, an
extra column for defining variable dwell times, and standard navigation functions.
The remote commands required to define the list mode data are described in
Chapter 14.19.12, "SOURce:LIST Subsystem", on page 1164.
Varying the RF Signal in List or Sweep Mode
To Next Page
Loading...