Configuring the Internal Baseband Source
R&S
®
SMW200A
266User Manual 1175.6632.02 ─ 30
5.6.3.3 Data Source
Access:
► Select "Baseband > Custom Digital Mod > Data Source".
This tab provides access to the settings necessary to select and configure the data
source, like access to data and list editors or direct selection of PRBS data.
For an overview of the supported data sources, refer to Chapter 5.5.1.1, "Data, Clock
and Control Signals and Sources in the Baseband", on page 224.
To access the extern serial data settings
Provide the external serial data and clock signals at the connectors listed in Table 5-3.
1. If a wideband baseband generator (R&S SMW-B9) is used, select "System Config
> Mode > Advanced".
2. In the "Custom Digital Modulation > Data Source" dialog, select "Data Source >
External".
Generating Custom Digital Modulated Signals
To Next Page
Loading...