Signal Routing and System Configuration
R&S
®
SMW200A
151User Manual 1175.6632.02 ─ 30
History, Clear History
List of the sent commands.
As long as this history list is not cleared ("Clear History"), you can select a command
from the list and send it again.
Commands Trace, Clear Trace
List of the sent commands and their results, where the results are displayed in blue
color.
To delete the trace, select "Clear Trace".
Show Connector
Access:
1. Select "Taskbar > System Config > System Configuration > External RF and I/Q".
2. Navigate to the required connector.
Select "External Instruments > Config ...".
3. In the "<Dig. Conn. Name>: External Instrument Configuration" dialog, select
"Show Connector".
The dialog displays the location of the selected connector.
The "Show Connector" function triggers the instrument to identify the connector on
the rear panel. The LED next to the selected connector blinks.
See also Chapter 4.3.1, "Physical Location of the Input and Output Interfaces",
on page 114.
Check Connections Settings
This dialog is available if an R&S SZU is configured and connected to the
R&S SMW, see "To connect and configure an R&S SZU" on page 200.
System Configuration Settings
To Next Page
Loading...