Signal Routing and System Configuration
R&S
®
SMW200A
200User Manual 1175.6632.02 ─ 30
Figure 4-25: Example: Connecting external instruments to the BBMM 1/2 of theR&S
SMW
(2xR&S
SGT)
3. In the block diagram, select "I/Q Digital".
The dialog confirms the selected configuration. The settings are retrieved and set
to fit to the connected R&S SGT.
To connect and configure an R&S SZU
The following example assumes a differential I/Q connection between the R&S SZU
and R&S SMW, equipped with wideband baseband generator (R&S SMW-B9). The
R&S SZU is connected to RF A.
For more information on the R&S SZU, see the SZU100A Getting Started manual at
www.rohde-schwarz.com/manual/szu100a.
How to Connect External Instruments and Configure the Signal Flow
To Next Page
Loading...