Signal Routing and System Configuration
R&S
®
SMW200A
150User Manual 1175.6632.02 ─ 30
The sent commands and their results are displayed in the "Command Trace" field, as
long as the trace is not deleted "Clear Trace". The sent commands are also listed in
the "History" list. As long as this history list is not deleted ("Clear History"), you can
select a command from the list and send it again.
See also:
●
"To create a remote control sequence or modify the initialization sequence"
on page 203
●
Example "Controlling the R&S SMW and external RF instruments with the same
application program" on page 908.
Settings:
Mode........................................................................................................................... 150
Command, Send Command........................................................................................150
File, Sequence, Send Sequence.................................................................................150
History, Clear History...................................................................................................151
Commands Trace, Clear Trace................................................................................... 151
Mode
You can send a single command ("Command") or a command sequence ("Sequence")
to the connected instrument.
Command, Send Command
Entry field for the SCPI commands.
You can enter a new command or select a previously sent command from the "His-
tory".
If the remote connection is active, select "Send Command" to execute the command.
Remote command:
:SCONfiguration:EXTernal:CODer<ch>:REMote:SEND on page 934
:SCONfiguration:EXTernal:BBMM<ch>:REMote:SEND on page 934
:SCONfiguration:EXTernal:FADer<ch>:REMote:SEND on page 934
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:SEND on page 934
:SCONfiguration:EXTernal:RF<ch>:REMote:SEND on page 934
File, Sequence, Send Sequence
Accesses the standard "File Select" dialog for loading of user-defined files with exten-
sion *.iec.
The provided navigation possibilities in the dialog are self-explanatory.
When a file is selected, its name and content are displayed, and the first command is
selected. You can send the commands one by one ("Send Command") or send the
entire sequence at once ("Send Sequence").
After a command is sent, the next command form the sequence is selected.
See also:
●
"To create a remote control sequence or modify the initialization sequence"
on page 203
●
"Initialization Sequence" on page 148
●
Chapter 11.5.1, "File Select Settings", on page 686.
System Configuration Settings
To Next Page
Loading...