Rohde & Schwarz R&S SMW200A - Page 934

Remote Control Commands
R&S
®
SMW200A
934User Manual 1175.6632.02 ─ 30
Example: See Example "Connecting and configuring external instrument"
on page 905.
Manual operation: See "Initialization Sequence" on page 148
:SCONfiguration:EXTernal:REMote:PURGe
Removes unused instruments from the pool of external instruments.
Example: See Example "Connecting and configuring external instrument"
on page 905.
Usage: Event
Manual operation: See "Clean Unused/Clean All" on page 145
:SCONfiguration:EXTernal:REMote:CLEan
Removes all instruments from the pool of external instruments.
Example:
See Example "Connecting and configuring external instrument"
on page 905.
Usage: Event
Manual operation: See "Clean Unused/Clean All" on page 145
:SCONfiguration:EXTernal:CODer<ch>:REMote:SEND <SendScpiCommand>
:SCONfiguration:EXTernal:FADer<ch>:REMote:SEND <SendScpiCommand>
:SCONfiguration:EXTernal:BBMM<ch>:REMote:SEND <SendScpiCommand>
:SCONfiguration:EXTernal:RF<ch>:REMote:SEND <SendScpiCommand>
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:SEND <SendScpiCommand>
Allows you to send SCPI commands to the RF instruments connected to the
R&S SMW.
Setting parameters:
<SendScpiCommand>"<SCPI syntax>"
String containing an SCPI command (query or setting)
Example: See Chapter 14.18, "SCONfiguration Subsystem", on page 903.
Usage: Setting only
Manual operation: See "Command, Send Command" on page 150
:SCONfiguration:EXTernal:IQOutput<ch>:CONNections:CHECk?
Queries the status of the required connections between the R&S SMW and the R&S
SZU.
R&S SZU is connected to the R&S SMW via USB.
SCONfiguration Subsystem