Rohde & Schwarz R&S SMW200A - Page 144

Signal Routing and System Configuration
R&S
®
SMW200A
144User Manual 1175.6632.02 ─ 30
Settings:
Remote Config Settings.............................................................................................. 144
Remote Control Settings.............................................................................................149
Show Connector..........................................................................................................151
Check Connections Settings.......................................................................................151
Remote Config Settings
Access:
► Select "Taskbar > System Config > System Configuration > External RF and I/Q >
External Instruments > Config ...".
Settings:
Detect/Scan.................................................................................................................145
Clean Unused/Clean All..............................................................................................145
External Instrument.....................................................................................................145
Set Symbolic Name.....................................................................................................146
Remote Channel......................................................................................................... 146
Hostname or IP Address.............................................................................................146
Device ID.....................................................................................................................146
RF Path.......................................................................................................................147
I/Q Output Type...........................................................................................................147
Frontend Configuration............................................................................................... 147
Initialization Sequence................................................................................................ 148
Remove Initialization Sequence..................................................................................148
Apply........................................................................................................................... 148
Apply and Connect......................................................................................................149
System Configuration Settings