Rohde & Schwarz R&S SMW200A - Page 147

Signal Routing and System Configuration
R&S
®
SMW200A
147User Manual 1175.6632.02 ─ 30
Remote command:
:SCONfiguration:EXTernal:REMote:ADD on page 930
:SCONfiguration:EXTernal:RF<ch>:REMote:INFO? on page 932
RF Path
In a two-path instrument, determines the RF output to be used.
Remote command:
:SCONfiguration:EXTernal:REMote:ADD on page 930
:SCONfiguration:EXTernal:CODer<ch>:REMote:INFO? on page 932
:SCONfiguration:EXTernal:FADer<ch>:REMote:INFO? on page 932
:SCONfiguration:EXTernal:CODer<ch>:REMote:INFO? on page 932
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:INFO? on page 932
:SCONfiguration:EXTernal:RF<ch>:REMote:INFO? on page 932
I/Q Output Type
Selects the type of output signal.
The provided parameters in the "I/Q Analog Outputs" dialog depend on the selected
output mode.
"Single-Ended"
●
If "RF Envelope > Off"
Single-ended output at the I/Q connectors.
Option: R&S SMW-B9: the signal from "I/Q Analog B" is output at
the I Bar connectors.
See Figure 4-3 and Figure 4-4.
●
If "RF Envelope > On"
The envelope signal E is output at the I connectors.
You can define a bias between the output signal and ground.
"Differential"
Option: R&S SMW-B10 and R&S SMW-K16
Or R&S SMW-B9 and R&S SMW-K17.
●
If "RF Envelope > Off"
The analog I/Q signal components are output at the I/Q and I/Q
Bar connectors.
See Figure 4-3 and Figure 4-4.
Option: R&S SMW-B9: the differential signal output can be activa-
ted in "I/Q Analog A" block only. Single-ended and differential sig-
nals cannot be output simultaneously.
●
If "RF Envelope > On"
The inverted envelope signal Ē is output at the I Bar connectors.
Remote command:
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:TYPE on page 1141
Frontend Configuration
Requires R&S SMW-K553.
Accesses the "RF Frontend" dialog to configure settings of the connected external
frontend.
For more information, see the document "R&S SMW-K553 Frontend Control User
Manual".
System Configuration Settings