Rohde & Schwarz R&S SMW200A - Page 1141

Remote Control Commands
R&S
®
SMW200A
1141User Manual 1175.6632.02 ─ 30
Manual operation: See "Save/Recall" on page 185
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:STORe <Filename>
Stores the current settings into the selected file; the file extension (*.iqout) is
assigned automatically.
Setting parameters:
<Filename> "<filename>"
Filename or complete file path
Usage: Setting only
Manual operation: See "Save/Recall" on page 185
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:LOAD
<Filename>
Loads the selected file from the default or the specified directory. Loaded are files with
extension *.iqout.
Setting parameters:
<Filename> "<filename>"
Filename or complete file path
Usage: Setting only
Manual operation: See "Save/Recall" on page 185
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:DELete <Filename>
Deletes the selected file from the default or specified directory. Deleted are files with
the file extension *.iqout.
Setting parameters:
<Filename> "<filename>"
Filename or complete file path
Usage: Setting only
Manual operation: See "Save/Recall" on page 185
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:TYPE <Type>
Sets the type of the analog signal.
Example:
SOURce1:IQ:OUTPup:ANALog:TYPE DIFFerential
Options: DIFFerential requires R&S SMW-K16
Manual operation: See "I/Q Output Type" on page 147
SOURce Subsystem