Remote Control Commands
R&S
®
SMW200A
917User Manual 1175.6632.02 ─ 30
Higher order MIMO configurations require option R&S SMW-K75
MIMO8X8 requires R&S SMW-K821 or R&S SMW-B15/K75
Manual operation: See "Signal Routing" on page 128
See "Entities (Users, Cells)" on page 128
See "BB Signals (Tx Antennas)" on page 129
See "Streams (Rx Antennas)" on page 129
:SCONfiguration:MIMO:SUBSet <Subset>
Sets the MIMO subset.
While simulating a 8x8 MIMO mode with two R&S SMW, the MIMO subset defines
which fading channels from the MIMO matrix are calculated by the selected instrument.
The MIMO subset selected in each of the two connected instrument has to be different.
Parameters:
<Subset> SET2 | SET1 | ALL
*RST: SET1 (R&S SMW-B9/-B14)/ALL(R&S SMW-B10/-
B15/-K75)
Example: See Example "Enbaling an 1x8x8 MIMO configuration with two
R&S SMW" on page 912.
Options: R&S SMW-K821
ALL requires R&S SMW-B10/-B15/-K75
Manual operation: See "Subset" on page 129
:SCONfiguration:BASeband:SOURce <SourConfig>
Determines whether coupled or separated baseband sources are used.
Parameters:
<SourConfig> SEParate | COUPled | CPENtity
SEParate
Enabled in LxMxN configurations with L ≤ 2 and M < 4
COUPled|CPENtity
Enabled in LxMxN configurations with L > 2
CPENtity enabled in LxMxN configurations with L > 1 and M >
1.
*RST: SEParate
Example: See Example "Distributing the I/Q streams to the output connec-
tors" on page 904.
Manual operation: See "Baseband Source Config" on page 130
:SCONfiguration:BBBW <Bandwidth>
Sets the bandwidth of the baseband signal at the inputs of the fading simulator.
SCONfiguration Subsystem
To Next Page
Loading...