Rohde & Schwarz R&S SMW200A - Page 1069

Remote Control Commands
R&S
®
SMW200A
1069User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:FREQuency?
Queries the pulse frequency of the pulsed marker signal. The pulse frequency is
derived by dividing the symbol rate by the divider.
Return values:
<Frequency> float
Increment: 0.001
Example: see Example "Managing waveform files" on page 1020
Usage: Query only
Manual operation: See "Marker Mode" on page 311
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay
<Delay>
Defines the delay between the signal on the marker outputs and the start of the sig-
nals.
Parameters:
<Delay> integer
Range: 0 to depends on other values
Increment: 0.001
*RST: 0
Default unit: Symbol
Example: See Example "Managing waveform files" on page 1020.
Manual operation: See "Marker x Delay" on page 257
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DINSec?
Queries the marker delay in microseconds.
You can define a marker delay in samples with [:SOURce<hw>]:BB:ARBitrary:
TRIGger:OUTPut<ch>:DELay.
Return values:
<DelayInS> float
Range: 0 to 16777215
Increment: 1E-3
*RST: 0
Usage: Query only
Manual operation: See "Delay (Time)" on page 311
SOURce Subsystem