Rohde & Schwarz R&S SMW200A - Page 1039

Remote Control Commands
R&S
®
SMW200A
1039User Manual 1175.6632.02 ─ 30
Example: see Example "Configuring the output order of the segments"
on page 1024
Usage: Query only
Manual operation: See "Current Segment/Current Segment Index" on page 370
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NAME?
Queries the name of the waveform of the currently output segment of the multi-seg-
ment waveform.
Return values:
<Name> string
Example: See Example "Configuring the output order of the segments"
on page 1024
Usage: Query only
Manual operation: See "Current Segment/Current Segment Index" on page 370
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NEXT <Next>
Selects the segment to be output.
Parameters:
<Next> integer
Range: 0 to 1023
*RST: 0
Example: see Example "Configuring the output order of the segments"
on page 1024
Manual operation: See "Segment" on page 370
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NEXT:EXECute
Triggers manually switchover to the subsequent segment in the multi-segment file.
This command is disabled, if a sequencing play list is enabled.
Example:
See Example "Configuring the output order of the segments"
on page 1024
Usage: Event
Manual operation: See "Execute Next Segment" on page 372
[:SOURce<hw>]:BB:ARBitrary:WSEGment:NEXT:SOURce <Source>
Selects the next segment source.
SOURce Subsystem