Remote Control Commands
R&S
®
SMW200A
1042User Manual 1175.6632.02 ─ 30
Setting parameters:
<FilenameInput> string
Complete file path, file name of the configuration file and file
extension (*.inf_mswv)
Example: See Example "Creating a multi-segment waveform"
on page 1022
Usage: Setting only
Manual operation: See "Save List/Save List As..." on page 360
See "Create/Create and Load" on page 360
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:MODE
<Mode>
Defines the way the marker information within the separate segments is processed.
Parameters:
<Mode> IGNore | TAKE
*RST: TAKE
Example: see Example "Adding extra marker signals" on page 1026
Manual operation: See "Segment Marker" on page 364
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:ESEGment
<Mode>
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:FSEGment
<Mode>
Enables/disables the generation of an additional marker restart signal at the beginning
of the first segment (FSEGment) or at the beginning of each segment (ESEGment).
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
Parameters:
<Mode> OFF | MRK1 | MRK2 | MRK3 | MRK4
*RST: OFF
Example: see Example "Adding extra marker signals" on page 1026
Manual operation: See "Sequence Restart" on page 365
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SMODe <SMode>
Selects the extended trigger mode for multi segment waveforms.
Parameters:
<SMode> SAME | NEXT | SEQuencer | NSEam
NSEam = Next Segment Seamless
*RST: NEXT
SOURce Subsystem
To Next Page
Loading...