Rohde & Schwarz R&S SMW200A - Page 1043

Remote Control Commands
R&S
®
SMW200A
1043User Manual 1175.6632.02 ─ 30
Example: See Example "Configuring the output order of the segments"
on page 1024.
Manual operation: See "Next Segment Mode" on page 371
Multi-Segment Sequencing Commands
Required options
See Chapter 5.10.1, "Required Options", on page 352.
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:BLANk:APPend............................1043
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:CATalog?.....................................1043
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:CLOCk........................................ 1044
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:CLOCk:MODE............................. 1044
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:LEVel[:MODE]..............................1044
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:COMMent....................................1045
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:DELete........................................1045
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe..........................................1045
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:SEGMent:APPend........................1045
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:SELect........................................ 1046
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:BLANk:APPend
<SampCount>, <Frequency>
Adds a blank segment to the multi-segment file.
Setting parameters:
<SampCount> float
Specifies the number of samples.
Range: 512 to 1E7
Increment: 1
*RST: 1000
<Frequency> float
Determines the clock rate.
Range: 400 Hz to depends on the installed options
Increment: 0.001
*RST: 1E8
Example: See Example "Creating a multi-segment waveform"
on page 1022
Usage: Setting only
Manual operation: See "Blank Segment" on page 362
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:CATalog?
Queries the available configuration files in the default directory. See also Chap-
ter 5.10.2.3, "File Concept", on page 353.
SOURce Subsystem