Rohde & Schwarz R&S SMW200A - Page 1273

Maintenance, Storage and Disposal
R&S
®
SMW200A
1273User Manual 1175.6632.02 ─ 30
The required remote commands are described in Chapter 14.20, "SYSTem Subsys-
tem", on page 1217.
Settings:
Date...........................................................................................................................1273
Time.......................................................................................................................... 1273
Timezone...................................................................................................................1273
NTP Address.............................................................................................................1273
Use Time from NTP Server....................................................................................... 1273
Date
Displays the date set in the operating system in the format [dd.mm.yyyy].
Remote command:
:SYSTem:DATE on page 1239
Time
Displays the time set in the operating system in the format [hh.mm.ss].
The time setting corresponds to the selected Use Time from NTP Server.
Remote command:
:SYSTem:TIME on page 1240
Timezone
Selects the timezone.
You can select the timezone according to the major cities on the respective continents.
Note: By typing the first letter, you can quickly navigate through the lists to find the
desired destination.
Remote command:
:SYSTem:TIME:ZONE on page 1240
:SYSTem:TIME:ZONE:CATalog? on page 1240
NTP Address
Sets the IP address or host name of the NTP server.
NTP is a network time protocol used for synchronizing all participating devices in a
data network.
You can select a high-precision time server to reduce the impact of varying network
delays.
Remote command:
:SYSTem:NTP:HOSTname on page 1239
Use Time from NTP Server
Activates clock synchronization of the network via the NTP protocol.
Remote command:
:SYSTem:NTP:STATe on page 1239
Performing Maintenance Tasks