Rohde & Schwarz R&S SMW200A - Page 1287

Maintenance, Storage and Disposal
R&S
®
SMW200A
1287User Manual 1175.6632.02 ─ 30
Remote command:
:TEST:BB:GENerator:SOURce on page 1250
Gain
Sets the gain for a sine or a constant I/Q test signal.
Remote command:
:TEST:BB:GENerator:GAIN on page 1249
Frequency
If "IQ Source = Sine", sets the frequency of the test signal.
Remote command:
:TEST:BB:GENerator:FREQuency on page 1249
Select ARB File
Provides access to the standard "File Select" function of the instrument. The provided
navigation possibilities in the dialog are self-explanatory.
See also, chapter "File and Data Management" in the R&S SMW User Manual.
Remote command:
:TEST:BB:GENerator:ARBitrary on page 1249
17.3.4.4 How to Set Up the R&S SMW for BNC Connections Tests
1. This function is password-protected. Unlock the protection level 1 to access it.
2. Select "System Config > Setup > Maintenance > Selftest > Connections".
3. Select the BNC Source (signal output).
4. Select the BNC Destination (signal input).
5. On the instrument, connect the selected "Source" connector with the "Destination"
connector.
The selection list in the dialog shows you where to find the associated connector
on the instrument.
6. Select "Execute BNC Connections Test".
17.3.5 FPGA/uC Update Settings
Access:
► Select "System Config > Setup > Maintenance > FPGA/µC Update".
Performing Maintenance Tasks