Monitoring Signal Characteristics
R&S
®
SMW200A
610User Manual 1175.6632.02 ─ 30
Reference Curves
Accesses the dialog for defining reference curves, see "Reference Curve"
on page 610.
Display Units
Changes the units of the X-axis. The available values depend on the generated signal.
Show / Hide marker
Sets two markers to the displayed signal or hides them.
See also:
●
"Using markers" on page 604
●
"To enable markers to readout exact measured data" on page 618
Reference Curve
Enable the indication of up to five configurable reference curves (traces).
See
"Reference trace" on page 604.
"Reference Curves Table"
Lists the configured reference curves and their current state.
To change a curve, select it.
"Name"
Enters the name of a new reference curve
"Assign Data"
Accesses the standard "File Select" function to load a file describing a
reference curve
"Show Curve"
Toggles the show/hide state of the selected curve
"Delete"
Removes the curve
Displaying Baseband Signal Characteristics in Real-Time
To Next Page
Loading...