Rohde & Schwarz R&S SMW200A - Page 1019

Remote Control Commands
R&S
®
SMW200A
1019User Manual 1175.6632.02 ─ 30
14.19.4.3 SOURce:BB:ARBitrary Subsystem
This section list the commands of the SOURce:BB:ARBitrary subsystem.
Suffixes in the keywords ENTity<ch> and SOURce<hw>
You can address multiple entities configurations by using the SCPI commands starting
with the keyword SOURce or the alias commands starting with the keyword ENTity.
Table 14-6: Value ranges of the suffixes ENTity<ch> and SOURce<hw> in advanced configuration
with multiple entities
SCPI Syntax
ENTity<ch> SOURce<hw>
SOURce<hw>:BB:...
- 1 to 8
ENTity<ch>:SOURce<hw>:BB:...
1 1 to 8
2 to 4 1 to 4
See also Chapter 14.3, "SCPI Command Aliases for Advanced Mode with Multiple
Entities", on page 842.
Required options
See Chapter 5.7.1, "Required Options", on page 296.
The commands are grouped in the following sections:
● Programming Examples......................................................................................1019
● General Commands............................................................................................1028
● Test Signal Commands....................................................................................... 1029
● Waveform Commands........................................................................................ 1033
● Multi-Segment Commands..................................................................................1038
● Multi-Segment Sequencing Commands..............................................................1043
● Multi-Carrier Commands.....................................................................................1046
● Notch Filter Commands...................................................................................... 1058
● Trigger Commands............................................................................................. 1061
● Marker Commands..............................................................................................1067
● Clock Commands................................................................................................1070
Programming Examples
Example: Creating test signals
The following example lists commands necessary to configure the different test sig-
nals.
// ******************************************************************
// Reset instrument first
// ******************************************************************
*RST; *CLS
SOURce:BB:ARBitrary:PRESet
SOURce Subsystem