Rohde & Schwarz R&S SMW200A - Page 1029

Remote Control Commands
R&S
®
SMW200A
1029User Manual 1175.6632.02 ─ 30
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See "Programming Examples" on page 1019
Manual operation: See "State" on page 303
[:SOURce<hw>]:BB:ARBitrary:PRAMp[:STATe] <ArbPramState>
If activated, the burst gate marker signal included in the ARB waveform file is used as
marker signal for the pulse modulator.
Parameters:
<ArbPramState> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce1:BB:ARBitrary:WAVeform:SELect "/var/user/Pulse_PMod_Burst"
SOURce1:BB:ARBitrary:PRAMp:STATe 1
SOURce1:BB:ARBitrary:STATe 1
Options: R&S SMW-K22
Manual operation: See "RF Power Ramping with Burst Marker" on page 306
Test Signal Commands
[:SOURce<hw>]:BB:ARBitrary:SIGNal:TYPE.................................................................. 1029
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:I..................................................................1030
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:Q................................................................1030
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:AMPLitude........................................ 1030
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:FREQuency...................................... 1030
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:OFFSet.............................................1031
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:SAMPles...........................................1031
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:FREQuency............................................... 1031
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:PHASe...................................................... 1031
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:SAMPles................................................... 1032
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate:NAMed........................................... 1032
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate:NAMed.................................1032
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed..........................................1032
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate....................................................... 1032
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate.............................................1032
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate..................................................... 1032
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:AWGN:SAMPles.................................................1033
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:AWGN:CREate...................................................1033
[:SOURce<hw>]:BB:ARBitrary:SIGNal:TYPE <ArbSignalType>
Selects the type of test signal.
SOURce Subsystem