Rohde & Schwarz R&S SMW200A - Page 1060

Remote Control Commands
R&S
®
SMW200A
1060User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:BB:ONEWeb:NOTCh<ch>:STATe <ValEnable>
[:SOURce<hw>]:BB:ARBitrary:NOTCh<ch>:STATe <ValEnable>
Enables the particular notch.
Parameters:
<ValEnable> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Creating notch filter" on page 1028.
Manual operation: See "State" on page 348
[:SOURce<hw>]:BB:DVB:NOTCh<ch>:FREQuency:OFFSet
<FreqOffs>
[:SOURce<hw>]:BB:EUTRa:NOTCh<ch>:FREQuency:OFFSet <FreqOffs>
[:SOURce<hw>]:BB:OFDM:NOTCh<ch>:FREQuency:OFFSet <FreqOffs>
[:SOURce<hw>]:BB:ONEWeb:NOTCh<ch>:FREQuency:OFFSet <FreqOffs>
[:SOURce<hw>]:BB:ARBitrary:NOTCh<ch>:FREQuency:OFFSet <ChBw>
Specifies the center frequency of the notch
Parameters:
<ChBw> integer
Range: -2000E6 to 2000E6
Increment: dynamic
*RST: 0
Example: See Example "Creating notch filter" on page 1028.
Manual operation: See "Frequency Offset /MHz" on page 348
[:SOURce<hw>]:BB:DVB:NOTCh<ch>:BWIDth[:ABSolute] <BwHz>
[:SOURce<hw>]:BB:EUTRa:NOTCh<ch>:BWIDth[:ABSolute] <BwHz>
[:SOURce<hw>]:BB:OFDM:NOTCh<ch>:BWIDth[:ABSolute] <BwHz>
[:SOURce<hw>]:BB:ONEWeb:NOTCh<ch>:BWIDth[:ABSolute] <BwHz>
[:SOURce<hw>]:BB:ARBitrary:NOTCh<ch>:BWIDth[:ABSolute] <NoBw>
Sets the absolute notch bandwidth.
The value is interdependent with the relative bandwidth value, set with the command
[:SOURce<hw>]:BB:ARBitrary:NOTCh<ch>:BWIDth:RELative.
That is, you cna set the notch bandwidth in either way.
Parameters:
<NoBw> float
Range: 0 to dynamic
Increment: dynamic
*RST: dynamic
Example: See Example "Creating notch filter" on page 1028.
Manual operation: See "Notch Bandwidth /MHz" on page 348
SOURce Subsystem