Monitoring Signal Characteristics
R&S
®
SMW200A
615User Manual 1175.6632.02 ─ 30
2. Select "Roll Off Factor", open the context menu, and select "Preset this parame-
ter".
To set and verify path gain and routing
The power spectrum diagram is a suitable representation of the effect of these set-
tings.
1. In the vector diagram, select "Graphics... > Mode > Power Spectrum", "Source >
RF" and "Apply Changes".
2. Select "Baseband > Baseband Offsets > Baseband > Frequency Offset = 5 MHz".
The power spectrum confirms the shifted WCDMA-3GPP signal.
Displaying Baseband Signal Characteristics in Real-Time
To Next Page
Loading...