Rohde & Schwarz R&S SMW200A - Page 634

Monitoring Signal Characteristics
R&S
®
SMW200A
634User Manual 1175.6632.02 ─ 30
a) Select "IEEE 802.11 WLAN > Frame Blocks > Append", configure "Frame
Block#2 > Boost = -5 dB" and "Frame Block#2 > State = On"
b) Select "IEEE 802.11 WLAN > General > State > On".
c) Select "IEEE 802.11 WLAN > Marker" and enable two marker signals, each
one indicating of the PPDU part of the frame block:
● "Marker Mode > Marker 1 > Frame Active Part", "Frame Block Index = 1",
"Frame Index = 1"
● "Marker Mode > Marker 2 > Frame Active Part", "Frame Block Index = 2",
"Frame Index = 1"
3. In the task bar, select "System Config > Setup > Baseband Powers" and perform
the following:
a) "Source > Baseband A" and "Output > RF A"
Querying Information on the Baseband Power Levels