Rohde & Schwarz R&S SMW200A - Page 7

Contents
R&S
®
SMW200A
7User Manual 1175.6632.02 ─ 30
5.10.5 Reference to Triggering of Multi-Segment Waveforms............................................... 378
5.11 Generating Multi-Carrier Signals............................................................................. 381
5.11.1 Required Options........................................................................................................ 382
5.11.2 About the Multi-Carrier Waveforms.............................................................................382
5.11.3 Multi-Carrier Settings.................................................................................................. 384
5.11.4 How to Use the Multi-Carrier Function........................................................................ 396
5.12 Generating Multi-Carrier Continuous Wave Signal................................................398
5.12.1 Required Options........................................................................................................ 399
5.12.2 About the MCCW........................................................................................................ 399
5.12.3 MCCW Settings...........................................................................................................399
5.12.4 How to Use the Multi-Carrier Continuous Wave Function...........................................406
5.12.5 References..................................................................................................................407
5.13 Generating a Linear Slope Ramp Waveform.......................................................... 408
5.14 Shifting and Boosting the Baseband Signal.......................................................... 408
5.14.1 About Baseband Offsets............................................................................................. 408
5.14.2 Baseband Offsets Settings..........................................................................................411
5.14.3 How to Improve Signal Characteristics by Shifting the Baseband Signal................... 413
6 Simulating Fading, Adding Noise and Predistortions, and Impairing
the Signal............................................................................................415
6.1 Simulating Fading..................................................................................................... 415
6.2 Adding Noise to the Signal...................................................................................... 415
6.2.1 Required Options........................................................................................................ 415
6.2.2 About the AWGN Generator........................................................................................416
6.2.3 AWGN Block............................................................................................................... 422
6.2.4 AWGN Settings........................................................................................................... 422
6.2.5 How to Configure the Noise Generator for Receiver Tests......................................... 430
6.3 Generating Impulsive and Phase Noise..................................................................432
6.3.1 Required Options........................................................................................................ 432
6.3.2 About the Impulsive Noise.......................................................................................... 433
6.3.3 About the Phase Noise............................................................................................... 433
6.3.4 Impulsive Noise Settings.............................................................................................435
6.3.5 Phase Noise Settings..................................................................................................437
6.4 Impairing the Signal..................................................................................................439