Rohde & Schwarz R&S SMW200A - Page 9

Contents
R&S
®
SMW200A
9User Manual 1175.6632.02 ─ 30
8.7.2 About Sweep Mode.....................................................................................................500
8.7.3 About List Mode.......................................................................................................... 504
8.7.4 Significant Parameters and Functions........................................................................ 505
8.7.5 Sweep Mode Settings................................................................................................. 508
8.7.6 List Mode Settings.......................................................................................................517
8.7.7 List Editor.................................................................................................................... 524
8.7.8 How to Generate a Signal in List or Sweep Mode...................................................... 527
8.8 Analog Modulations..................................................................................................529
8.8.1 Required Options........................................................................................................ 531
8.8.2 Modulation Signals......................................................................................................531
8.8.3 Activating Analog Modulations.................................................................................... 539
8.8.4 Modulation Settings.....................................................................................................540
8.8.5 How To Generate a Modulated Signal........................................................................ 561
8.9 Improving Level Performance..................................................................................562
8.9.1 Attenuator....................................................................................................................563
8.9.2 ALC - Automatic Level Control....................................................................................566
8.9.3 User Correction........................................................................................................... 570
8.9.4 Using Power Sensors..................................................................................................581
8.9.5 How to Calibrate the Power Level with an R&S NRP Power Sensor..........................593
9 Monitoring Signal Characteristics....................................................597
9.1 Displaying Baseband Signal Characteristics in Real-Time...................................597
9.1.1 Required Options........................................................................................................ 597
9.1.2 About the Graphical Signal Display.............................................................................597
9.1.3 Graphics Configuration Settings................................................................................. 605
9.1.4 Graphical Signal Display Settings............................................................................... 608
9.1.5 How to Verify the Generated Signal with the Graphics Display...................................611
9.2 Querying Information on the Baseband Power Levels..........................................621
9.2.1 Required Options........................................................................................................ 621
9.2.2 About Leveling............................................................................................................ 621
9.2.3 Baseband Powers Settings......................................................................................... 627
9.2.4 How to Query Information on the Baseband Power Levels........................................ 630
10 Multi-Instrument Setups....................................................................639
10.1 Synchronizing Instruments......................................................................................639