Getting Started
R&S
®
SMW200A
95User Manual 1175.6632.02 ─ 30
1 2 3
4 5 6
Figure 3-23: Taskbar fully assigned
1 = System configuration
2 = Remote control connections
3 = R&S NRP power sensors
4 = Graphics
5 = Dialogs
6 = Diagram / more
1 System Config Provides access to general system configurations like
setup, display, or remote.
The warning symbol signifies a permanent error message.
It replaces the default symbol, as shown in Figure 3-22.
2 Remote Shows the established remote connections when the
instrument is remotely controlled.
Tip: An indicator in the status bar shows the current
remote control status.
3 R&S NRP Shows a connected external power sensor.
If the sensor is active, the softkey background is blue.
4 Graphics Shows that a signal is represented graphically.
5 Dialogs Shows a dialog as a thumbnail, the dialog name, and the
name of signal channel.
6 Diagram / more The diagram icon as shown in Figure 3-22 minimizes all
dialogs indicated on the screen. The block diagram is in
the foreground.
The "More" softkey indicates that more dialogs are open
than can be displayed in the taskbar. Use this softkey to
open a selection list with the remaining active dialogs, and
the "Diagram" function.
3.5.3.4 Additional Display Characteristics
The following section provides a short insight on the indication of the screen in general,
and significant elements that you see under specific operating modes, in dialogs or set-
tings.
●
Appearance of active elements
– Active elements like On/Off switches, state buttons have a blue background.
– Selected elements are framed or highlighted orange.
– Inactive elements are gray.
●
On-Screen keypads
As additional means of interacting with the instrument without having to connect an
external keyboard, either a numerical or alphanumerical on-screen keypad appears
when you activate an entry field (see Chapter 3.5.5, "Entering Data", on page 98).
●
Info line
Instrument Control
To Next Page
Loading...