Network connections and remote operation
R&S
®
RTM3000
244User Manual 1335.9090.02 ─ 09
12.2.2 USB VCP
USB VCP uses the virtual COM port (VCP) to communicate with the measuring instru-
ment. You can use any terminal program to send SCPI commands. USB VCP requires
a USB VCP driver on the controlling computer. If the computer requests a driver instal-
lation, you can download the driver at the Rohde & Schwarz website (www.rohde-
schwarz.com/de/treiber/hmo/, HO732). You need administrator rights to install the
driver.
12.2.3 USB MTP
USB MTP is the USB media transfer protocol. It is a solution to load data from the
oscilloscope to the computer. Remote control using SCPI commands is not possible.
USB MTP does not need a driver installation. Connect a USB cable to the USB type B
connector at the instrument and to the computer (USB type A). Select USB MTP as
interface, and you can access the oscilloscope data from the computer. You see the
oscilloscope in the computer's Device Manager and in the file explorer as portable
instrument.
12.3 Remote access using a web browser
The R&S RTM3000 firmware contains a web server. If a LAN connection is estab-
lished, you can access the instrument remotely using a web browser on the control
computer.
The browser access allows you to:
●
Check instrument data
●
Save and print screenshots
●
Send remote commands
●
Save waveform and instrument data
●
Check network settings
●
Change the password
●
See a live view of the display
●
Control the instrument remotely
12.3.1 Accessing the instrument using a web browser
To access the R&S RTM3000, you need a LAN connection and the IP address of the
instrument.
1. Obtain the IP address of the R&S RTM3000:
● Tap the green network icon in the top right corner of the screen.
Remote access using a web browser
To Next Page
Loading...
Need help?
General
