Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
601User Manual 1335.9090.02 ─ 09
Parameters:
<IPPort> Range: 1024 to 65535
SYSTem:COMMunicate:INTerface:ETHernet:VXIPort <VXIport>
Specifies the VXI-11 port number.
Parameters:
<VXIport> Range: 0 to 65535
*RST: 1024
SYSTem:COMMunicate:INTerface:ETHernet:HTTPport <HTTPport>
Returns the HTTP port number.
Parameters:
<HTTPport> Range: 0 to 65535
*RST: 80
SYSTem:COMMunicate:INTerface:ETHernet:TRANsfer <TransferMode>
Enables automatic transfer speed selection, or selects one of the predefined settings
that corresponds to your network data rate.
Parameters:
<TransferMode> AUTO | FD10 | FD100 | HD10 | HD100
AUTO
Automatic transfer speed
FD10 | FD100 | HD10 | HD100
FD = full duplex, HD = half duplex
10 = 10 Mbps, 100 = 100 Mbps
SYSTem:COMMunicate:INTerface:ETHernet:MACaddress?
Returns the instrument's media access control address.
Return values:
<MACaddress> String data
String parameter
Usage: Query only
17.10.4 USB settings
The following command takes effect if SYSTem:COMMunicate:INTerface[:
SELect] is set to USB.
General instrument setup