Waveform analysis
R&S
®
RTM3000
120User Manual 1335.9090.02 ─ 09
Remote command:
REFCurve<m>:UPDate on page 485
State
Activates the reference waveform and displays it.
Remote command:
REFCurve<m>:STATe on page 485
Load Reference
Provides functions to load a reference waveform. You can load CSV and TRF files.
Select the "Location" of the waveform file (internal or USB), and the file. Tap "Load Ref-
erence".
You can also delete obsolete files in the dialog box.
Remote command:
REFCurve<m>:LOAD on page 485
Load Setup
Loads the device settings that were used to obtain the stored reference waveform. The
settings are only available if the file was stored to the internal storage and never written
to a USB flash device.
Load the reference waveform first, and then the settings. If settings were not stored,
"Load Setup" is not active.
Remote command:
REFCurve<m>:LOAD:STATe on page 486
Save Reference
Opens a dialog box to save a waveform as reference waveform:
"Source"
Select the waveform to be saved. You can save any active analog
channel, math or reference waveform, or logic pod.
"Destination"
Select the "Location" (internal directory or USB flash device), and the
target directory.
"File Name"
Enter the filename. If a file with the same filename already exists in
the destination directory, it will be overwritten without notification. The
file format is TRF.
"Comment"
Optionally, enter text to describe the waveform.
"Save"
Saves the data.
Remote command:
REFCurve<m>:SAVE on page 485
Waveform Color
Selects a color for the reference waveform. The default color is white. You can select
another monochrome color, or a color scale.
The color scales are described in "Waveform Color" on page 58.
Remote command:
REFCurve<m>:WCOLor on page 487
Reference waveforms
To Next Page
Loading...
Need help?
General
