Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
561User Manual 1335.9090.02 ─ 09
Parameters:
<Enable> ON | OFF
TCOunter:SOURce
Sets the measurement source for the counter.
Parameters:
<CounterSource> CH1 | CH2 | CH3 | CH4 | TRIGger
TRIGger: Trigger source
*RST: TRIG
TCOunter:RESult[:ACTual]:FREQuency?
Returns the frequency of the trigger source.
Return values:
<FrequencyValue> Default unit: Hz
Usage: Query only
TCOunter:RESult[:ACTual]:PERiod?
Returns the period of the trigger source.
Return values:
<PeriodValue> Default unit: s
Usage: Query only
17.8.8 Bode plot (option R&S RTM-K36)
17.8.8.1 Bode plot setup
BPLot:ENABle............................................................................................................... 562
BPLot:AUToscale........................................................................................................... 562
BPLot:AMPLitude:PROFile:COUNt.................................................................................. 562
BPLot:AMPLitude:PROFile:POINt<n>:AMPLitude............................................................. 562
BPLot:AMPLitude:PROFile:POINt<n>:FREQuency............................................................562
BPLot:AMPLitude:MODE................................................................................................562
BPLot:FREQuency:DATA?.............................................................................................. 563
BPLot:FREQuency:STARt...............................................................................................563
BPLot:FREQuency:STOP............................................................................................... 563
BPLot:INPut[:SOURce]...................................................................................................563
BPLot:MEASurement:DELay...........................................................................................563
BPLot:MEASurement:POINt[:DISPLAY]............................................................................564
BPLot:OUTPut[:SOURce]............................................................................................... 564
BPLot:POINts:LOGarithmic.............................................................................................564
Applications