Rohde & Schwarz RTM3K-COM2 User Manual

Remote control commands
R&S
®
RTM3000
450User Manual 1335.9090.02 ─ 09
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<ZHDRange> AUTO | MHIGh | MLOW
AUTO
The voltage range is set only at the oscilloscope by adjusting the
vertical scale.
MHIGh
Sets the higher voltage range of the connected probe.
MLOW
Sets the lower voltage range of the connected probe.
*RST: AUTO
PROBe<m>:SETup:ACCoupling
<ProbeCouplingAC>
Enables AC coupling in R&S RT-ZPR probes, which removes DC and very low-fre-
quency components. The R&S RT-ZPR probes requires 50 Ω input termination, for
which the channel AC coupling is not available. The probe setting allows AC coupling
also at 50 Ω inputs.
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<ProbeCouplingAC> ON | OFF
*RST: OFF
17.4.6 R&S ProbeMeter
PROBe<m>:PMETer:VISibility......................................................................................... 450
PROBe<m>:SETup:OFFSwitch....................................................................................... 450
PROBe<m>:SETup:DCOFfset?.......................................................................................451
PROBe<m>:PMETer:RESults:SINGle?.............................................................................451
PROBe<m>:PMETer:RESults:COMMon?......................................................................... 451
PROBe<m>:PMETer:RESults:DIFFerential?..................................................................... 451
PROBe<m>:PMETer:RESults:NEGative?......................................................................... 452
PROBe<m>:PMETer:RESults:POSitive?.......................................................................... 452
PROBe<m>:PMETer:VISibility <State>
PROBe<m>:SETup:OFFSwitch <State>
Switches the integrated voltmeter of a Rohde & Schwarz active probe on or off. The
command is only relevant if a Rohde & Schwarz active probe with R&S ProbeMeter is
used.
Waveform setup

Rohde & Schwarz RTM3K-COM2 Specifications

General

Brand	Rohde & Schwarz
Model	RTM3K-COM2
Category	Test Equipment
Language	English