Network connections and remote operation
R&S
®
RTM3000
245User Manual 1335.9090.02 ─ 09
● "Setup" menu > "Interface" > "Ethernet" > "Parameter" > "IP".
2. Open an Internet browser on the control computer.
3. Enter the IP address of the R&S RTM3000 in the address line: http://
xxx.yyy.zzz.xxx.
The "Instrument Home" page opens.
If already another user is using the instrument via web access, connection is not possi-
ble, and you get an information about that.
12.3.2 Instrument home
The "Instrument Home" page provides information on the instrument and the LAN con-
nection.
12.3.3 Screenshot
The "Screenshot" page shows a copy of the instrument's display. It also provides
instrument control functions and screenshot settings.
Instrument control
●
"Run" and "Stop" = start and stop continuous acquisition, same as [Run Stop] key
on the instrument.
●
"Single" = Single key on the instrument
●
"Autoset" = [Autoset] key on the instrument
Remote access using a web browser
To Next Page
Loading...
