Remote control commands
R&S
®
RTM3000
599User Manual 1335.9090.02 ─ 09
Return values:
<ErrorList> List of ErrorFormat
List of: Error/event_number,"Error/event_description>[;Device-
dependent info]"
If the queue is empty, the response is 0,"No error"
Usage: Query only
SCPI confirmed
SYSTem:PRESet
Resets the instrument to the default state, has the same effect as *RST.
Usage:
Event
SYSTem:EDUCation:PRESet
Deletes the password of the education mode.
Usage:
Event
SYSTem:DFPRint?
Returns the device footprint of the instrument. The device footprint contains the config-
uration of the instrument, installed modules, installed software and software licenses.
This information is written in the device footprint xml file might be useful in case of
maintenance or support request.
Return values:
<DeviceFootprint> Block Data
Information as block data.
Usage: Query only
SYSTem:TREE?
REturns a list of the implemented remote commands.
Return values:
<SystemTree> List of commands
Usage: Query only
17.10.3 LAN settings
The following commands take effect if SYSTem:COMMunicate:INTerface[:
SELect] is set to ETHernet.
General instrument setup
To Next Page
Loading...
Need help?
General
