Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
454User Manual 1335.9090.02 ─ 09
Parameters:
<AcquisitionTime> Range and increment depend on time base (horizontal scale)
and other settings
Range: 250e-12 to 500
Increment: 1e-12
Default unit: s
TIMebase:DIVisions?
Queries the number of horizontal divisions on the screen.
Return values:
<HorizDivCount> Returns 12 divisions.
Usage: Query only
TIMebase:RATime?
Queries the real acquisition time used in the hardware. If FFT analysis is performed,
the value can differ from the adjusted acquisition time (TIMebase:ACQTime).
Return values:
<HWAcqTime> Range: Depends on various settings
Default unit: s
Usage: Query only
17.4.8 Acquisition settings
ACQuire:POINts:AUTomatic............................................................................................454
ACQuire:POINts[:VALue]................................................................................................ 455
CHANnel<m>:TYPE.......................................................................................................455
ACQuire:TYPE.............................................................................................................. 456
CHANnel<m>:ARIThmetics.............................................................................................456
ACQuire:PEAKdetect..................................................................................................... 457
ACQuire:HRESolution.................................................................................................... 457
ACQuire:NSINgle:COUNt................................................................................................457
ACQuire:AVERage:COUNt..............................................................................................457
ACQuire:AVERage:RESet...............................................................................................457
ACQuire:AVERage:COMPlete?....................................................................................... 457
TIMebase:ROLL:AUTomatic............................................................................................458
TIMebase:ROLL:MTIMe..................................................................................................458
ACQuire:INTerpolate...................................................................................................... 458
ACQuire:POINts:ARATe?................................................................................................459
ACQuire:SRATe?........................................................................................................... 459
ACQuire:POINts:AUTomatic <AutoRecordLength>
Enables or disables the automatic record length. The instrument sets a value that fits
to the selected timebase.
Waveform setup