Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
758User Manual 1335.9090.02 ─ 09
POWer:SOA:RESult:TOTal:VIOLation<n>:CURRent:DATA:YORigin?
POWer:SOA:RESult:TOTal:VIOLation<n>:VOLTage:DATA:YORigin?
Return the voltage value for binary value 0 of the indicated waveform.
Return values:
<Yorigin>
Usage: Query only
POWer:SOA:RESult:TOTal:VIOLation<n>:CURRent:DATA:YRESolution?
POWer:SOA:RESult:TOTal:VIOLation<n>:VOLTage:DATA:YRESolution?
POWer:SOA:REPort:ADD
POWer:SOA:RESTart
POWer:SOA:SCALe <>
POWer:SOA:SCALe:DISPlay <>
POWer:SOA:SCALe:MASK <>
Sets the scale for the mask, linear or logarithmic.
17.12.15 Spectrum
POWer:SPECtrum:EXECute........................................................................................... 758
POWer:SPECtrum:FREQuency.......................................................................................758
POWer:SPECtrum:REPort:ADD...................................................................................... 759
POWer:SPECtrum:RESult<n>:FREQuency?.....................................................................759
POWer:SPECtrum:RESult<n>:LEVel[:VALue]?..................................................................759
POWer:SPECtrum:RESult<n>:MAXimum?....................................................................... 759
POWer:SPECtrum:RESult<n>:MEAN?.............................................................................759
POWer:SPECtrum:RESult<n>:MINimum?........................................................................ 760
POWer:SPECtrum:RESult<n>:RESet...............................................................................760
POWer:SPECtrum:RESult<n>:WFMCount?......................................................................760
EXPort:POWer:NAME.................................................................................................... 760
EXPort:POWer:SAVE..................................................................................................... 760
POWer:SPECtrum:EXECute
Starts the spectrum measurement.
Usage:
Event
POWer:SPECtrum:FREQuency <SwitchingFrequency>
Sets the frequency of the input signal.
Parameters:
<SwitchingFrequency>
Power analysis (option R&S RTM-K31)