Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
459User Manual 1335.9090.02 ─ 09
ACQuire:POINts:ARATe?
Retrieves the sample rate of the ADC, that is the number of points that are sampled by
the ADC in one second.
Return values:
<ACDsampleRate> ADC sample rate
Default unit: Hz
Usage: Query only
ACQuire:SRATe?
<SampleRate>
Returns the sample rate, that is the number of recorded waveform samples per sec-
ond.
Parameters:
<SampleRate> Default unit: Sa/s
Usage: Query only
17.4.9 Waveform data
Use the following commands are described in Chapter 17.9.1.2, "Analog channels",
on page 571:
●
FORMat[:DATA] on page 569
●
CHANnel<m>:DATA? on page 571
●
CHANnel<m>:DATA:HEADer? on page 572
●
CHANnel<m>:DATA:POINts on page 572
●
CHANnel<m>:DATA:ENVelope? on page 573
●
CHANnel<m>:DATA:ENVelope:HEADer? on page 574
●
CHANnel<m>:DATA:XINCrement? on page 579
●
CHANnel<m>:DATA:XORigin? on page 579
●
CHANnel<m>:DATA:YINCrement? on page 580
●
CHANnel<m>:DATA:YORigin? on page 579
●
CHANnel<m>:DATA:YRESolution? on page 580
●
CHANnel<m>:DATA:ENVelope:XINCrement? on page 579
●
CHANnel<m>:DATA:ENVelope:XORigin? on page 579
●
CHANnel<m>:DATA:ENVelope:YINCrement? on page 580
●
CHANnel<m>:DATA:ENVelope:YORigin? on page 579
●
CHANnel<m>:DATA:ENVelope:YRESolution? on page 580
Waveform setup