Trigger
R&S
®
RTM3000
79User Manual 1335.9090.02 ─ 09
Remote command:
TRIGger:A:LEVel<n>[:VALue] on page 462
TRIGger:A:FINDlevel on page 462
[Force Trigger]
Provokes an immediate single acquisition. Use this key if the acquisition is running in
normal mode and no valid trigger occurs. Thus, you can confirm that a signal is availa-
ble and use the waveform display to determine how to trigger on it.
Remote command:
*TRG on page 433
[Run Stop]
Starts and stops the continuous acquisition. A green light indicates a running acquisi-
tion. A red light shows that acquisition is stopped.
The status is shown also at the right end of the information bar: "Run", "Complete",
"Trig?" (waiting for trigger, in normal trigger mode) or "Not ready" (working). For slow
timebases, the status "Pre" or "Post" is shown together with an indicator that shows the
filling level of the buffer.
Remote command:
RUN on page 434
RUNContinous on page 434
STOP on page 435
ACQuire:STATe on page 435
[ Single]
Starts a specified number of acquisitions. A white light indicates that the instrument is
in single mode. The information bar shows "Complete" if the acquisition has been fin-
ished.
If the history option R&S RTM-K15 is available, you can set the number of acquisitions:
press the [Acquisition] key and enter "Nx Single".
Remote command:
SINGle on page 434
RUNSingle on page 434
6.2 Shortcuts for trigger settings
To adjust the trigger source, mode, and trigger type specific settings, you can use the
shortcuts on the top of the display. The labels show the current values.
Shortcuts for trigger settings
To Next Page
Loading...
Need help?
General
